I have searched the forum for an answer to the hardware problem I am having - no luck so far.
Tested and working ok on mac via standard firewire (which as you know does not need Power Supply Unit).
On my PC laptop I'm using the firewire adapter (together with Power Supply Unit) - no lights on the front panel come up.
On the rear panel the I can see a red LED light behind the S/PDIF TOSLINK IN AND OUT CONNECTORS
So the Power Supply seems to be working.
When I first connect the power supply unit to the FW-410 there is a flash of lights on the front panel for a fraction of a second. The FW-410 is not being seen by the PC at all & I have removed & re-installed the drivers as suggested by the M-Audio knowledge base.
I have used this setup for years & only just recently wanted to use this setup again for an important project after a year of non-use.
Any advice??
Driver: 5.10.00.5054v2
O/S: Win XP SP2
Tested and working ok on mac via standard firewire (which as you know does not need Power Supply Unit).
On my PC laptop I'm using the firewire adapter (together with Power Supply Unit) - no lights on the front panel come up.
On the rear panel the I can see a red LED light behind the S/PDIF TOSLINK IN AND OUT CONNECTORS
So the Power Supply seems to be working.
When I first connect the power supply unit to the FW-410 there is a flash of lights on the front panel for a fraction of a second. The FW-410 is not being seen by the PC at all & I have removed & re-installed the drivers as suggested by the M-Audio knowledge base.
I have used this setup for years & only just recently wanted to use this setup again for an important project after a year of non-use.
Any advice??
Driver: 5.10.00.5054v2
O/S: Win XP SP2