I just installed Protools 10 on a 64 bit Windows 7 system with 8 gb of memory and 2 tb of harddrive space. I purchase my ProjectMix controller almost a year ago and am just getting around to getting my system ready for protools. I was able to update the drivers for the ProjectMix because I purchased the floor model from GC and they didn't have anything but the unit ( no power cable, firewire cable, etc.). The problem I am having with my unit is my fader controls are not moving or communicating with protools. I loaded the demo and it has fader movement and my projectMix doesn't function. I can move the assignable encorders and because they seem to be fixed on pan, that will work. I can use my transport functions, and I have been successful recording a live track, however, in all cases the faders are non-responsive. Is there a test that can be ran to rule out all my faders been bad? I have read the manual up and down and I can not find what I am doing wrong. I have found a few forum entries that have had simular problems however, they have had problems getting the peripherals to see a receive from assignment. The fix for that is...go to setup, MIDI input Enable and select the ProjectMix Control Surface MIDI and it will restore that function. My Pan light is always on as well, not sure if that means anything?
↧